Micro Jig Miter Bars Make the Ultimate Cross Cut Sled
Build woodworking sleds in minutes. For table saws, router tables, and band saws. The defining feature and flaw of aftermarket miter bars are one in the same - set screws. Frustrated with the difficulty of fitting miter bars with set screws.
Founder and inventor, Henry Wang, set out to change it. He conceived a method of adjustment based on opposing wedges, that adjusted the entire bar evenly in a single motion. With its One-Touch Calibration and top-down installation, the age-old struggles of sled making had finally been solved.
ZEROPLAY Mitre Stop – reliable and precise hold-down anchors for table saw tops and mitre tracks.
- Build custom hold-downs for t-mitre slots.
- Accurate repeat cuts for sliding table saw sleds.
- Perfect for clamping , slotting, stopping, and more.
- Use for point A and B stops for slotting.
- Locks woodworking jigs in position.
- Fits any standard 19.0 x 9.5mm (3/4” x 3/8”) T-Mitre Slots.
Mitre Slider Zero-Play 457mm 18in Each
Create perfectly square crosscut jigs fast. The ZeroPlay Mitre Bar System takes miter bars and table saw sleds to the next level of precision. By using the One-Touch Calibration, you instantly fill the full width of the miter slot for no side-to-side play.
Top-down installation lets you keep your sled square to the fence while you secure the ZeroPlay Mitre Bar for a hassle-free setup and precision cuts. Fits any standard 19.0 x 9.5mm (3/4” x 3/8”) T-Mitre Slots.
Long sleds? ZeroPlay Mitre Bars are available in double packs.
Use two ZEROPLAY Miter Bars in tandem to create long sleds and jigs. Handle larger materials safer and more accurately. When you purchase the ZeroPlay Twin Pack you also get two ZeroPlay Mitre Stops included in the kit.