Sherwood Zero-Clearance Insert for 10in and 14in Heavy-Duty Bandsaws
Check store availability
-
Melbourne, VICIn stock10+
-
Balcatta, WAIn stock0
-
Canning Vale, WAIn stock0
Sale ends in:
Sherwood Zero-Clearance Insert for 10in and 14in Heavy-Duty Bandsaws is available for pre-order and will ship as soon as stock arrives.
Request Further Information
Sherwood Zero-Clearance Insert for 10in and 14in Heavy-Duty Bandsaws
Eligible for FREE Shipping*
This accessory fits the Sherwood SBSHD-250 and SBSHD-350
A zero-clearance insert is the best way to ensure a clean cut on your bandsaw.
The clearance on the standard insert that is included with the machine is large enough to allow the table to be tilted. However, this gap can allow small offcuts to fall through the table and foul on the lower blade guides. It also fails to provide maximum support to the workpiece directly next to the blade, leading to rough and chipped edges, especially when crosscutting with low tpi blades or when cutting plywood and laminates.
Sherwood’s Zero-Clearance Inserts for the 10in and 14in Heavy-Duty Bandsaws solves these issues, delivering clean and safe cuts on all materials. They are produced from 2mm thick aluminium and machined to fit the table recess perfectly. They are stable, flat, and easy to install.
- Support what you’re cutting right up to the blade.
- Stop offcuts falling through and jamming the guides
- Reduce chip-out and tearing on the underside of the workpiece, especially when crosscutting, or on plywood and laminates.
Note: angled cuts should be made with the original insert, because these cuts require more blade clearance.
Zero Clearance Insert for 10 in HD Bandsaw
> The Insert is a good fit to the diameter of the recess in the table
> And the process for cutting the blade slot in the insert works well
> AND I had hoped that the insert, when fitted, would be accurately flush with the table
> BUT, BUT the recess in the table is 4mm deep
> AND both the standard insert and the zero-clearance insert are 2.5mm thick
SO, however I use the inserts - singly or in combination - the work can "trip" as it crosses the recess
It would be great to fix this; maybe a 1.5mm spacer ring for the recess?
Thank you
Works as described and very useful for some of the work I do on the bandsaw
Fits well easy to set up a great upgrade