Chamfered edges on vertical panel raises with an easy-to-use router bit
Standard panel raising bits are at least 79mm diameter and are usually daunting for novice furniture makers. Vertical panel raising bits are significantly smaller diameter with the only difference that you run the work piece vertically in a router table. The only drawback of these bits is that they can only machine rectangular frames.
For a modern kitchen door simply cut the profile of these bits on the edge of MDF panels and finish them either in clear coat or high-gloss paint minus the rail and stile frame.
**These bits must be used in a router table with fence.
1/2in shank vertical panel raising bit chamfer