Rules & Tapes

Incra Bend Rules make dual-surface layouts a snap using the corner slots. It also provides zero-parallax measuring on any flat surface. Micro-fine marking holes at every ¼mm instantly locate your sharp pencil point exactly on target with zero uncertainty and no eye-strain! The? 90° shape holds it snugly in place and there are even two vertical end scales for drawing precision parallel lines relative to the edge of your work.

Find the exact centre of any work piece up to 300mm wide. In addition to top and bottom micro-fine marking holes at every 1mm it also has a built-in protractor with guide slots at every 45°, 30°, 22.5°, and 5° interval.

Incra scores again with its precision steel rule. Select the proper slot or hole, insert a .5mm mechanical pencil, and mark the measurement with dead-on accuracy. These Marking Rules are precisely what's needed for accuracy by offering marking holes at every ¼mm! This is unmatched in the industry of marking rules.

With the addition of a fence you can now quickly and accurately mark anything from a work piece edge, as well as use the T-rule as an accurate layout square. Slide the fence along the work piece with 0.5mm mechanical pencil or scribe in place to use as a marking/mortice gauge too. The end has height marking slots 50mm high to expand its usefulness even more. 

  » View More

  » View More

  » View More

Never have torn pants from your tape measure again. With the SpeedClip, securing your tape measure is a breeze. It easily clips over your pants or belt, plus it even holds your pencil and has a built-in sharpener. 

  » View More

  » View More

  » View More

  » View More

  » View More

  » View More

  » View More

  » View More